Brake Light Switch: Adjustments

Stop Lamp Switch:

1. Depress and hold the brake pedal while rotating the stop lamp switch in a counterclockwise direction approximately 30°.
2. Pull the switch rearward and remove it from its mounting bracket.
3. Disconnect the wiring harness connector from the stop lamp switch.
4. Hold the stop lamp switch firmly in one hand. Using the other hand, pull outward on the plunger of the stop lamp switch until it has ratcheted out to its fully extended position.
5. Connect the wiring harness connector to the stop lamp switch.
6. Mount the stop lamp switch into the bracket using the following procedure:
- Depress the brake pedal as far down as possible.
- Install the switch in its bracket by aligning the index tab on the switch with the slot in the mounting bracket.
- When the switch is fully seated in its bracket, rotate the switch clockwise approximately 30° to lock the switch into place.

7. Connect the wiring harness connector to the stop lamp switch.

CAUTION: Do not use excessive force when pulling back on the brake pedal to adjust the stop lamp switch. If too much force is used, the stop lamp switch or striker can be damaged.

8. Gently pull back on the brake pedal until the pedal stops moving. This will ratchet the switch plunger backward to the correct adjustment position.
9. Check the stop lamps to verify they are operating properly and not staying on when the pedal is in the released position.