Ash Tray Lamp: Service and Repair

Ash Receiver Retainer and Lamp

REMOVAL
1. Open up and remove the ash receiver receptacle.
2. Remove the center bezel.
3. Remove the two ash receiver retainer attaching screws from the upper-rearward face and remove retainer.
4. For lamp replacement, remove the clamp and lamp hood from the top of the retainer. Remove the wiring clip at the forward edge of the retainer and remove the lamp socket from the hood and replace lamp.

INSTALLATION
For installation reverse the above procedures. When installing the retainer ensure that the forward tabs are inserted properly into the slots in the instrument panel.