Instrument Panel Right Trim Panel Replacement

REMOVAL
1. Disconnect and isolate the negative battery cable.

Instrument Panel Assembly:

2. Using a trim stick (special tool #C4755), gently pry up on the top cover and cluster bezel to remove.
3. Open the ash receiver.
4. Using a trim stick (special tool #C-4755), gently pry out on the center bezel and remove.
5. Remove the six attaching screws across the forward portion of the right upper trim panel. Then pull the panel rearward to disengage the three locator pins and remove.
6. Reach in and disconnect the wiring connectors. for the rear window defogger and/or fog lamp switchs. as required.

INSTALLATION
- For installation, reverse the above procedures.