Caliper Seal Removal

CAUTION: Do not use excessive force when clamping caliper in vise. Excessive vise pressure will cause bore distortion.

1. To disassemble the caliper, mount it in a vise equipped with protective jaws.

Fig. 10 Dust Boot Removal:

2. Remove the piston dust boot from the caliper and discard.

NOTE: Do not use a screw driver or other metal tool for seal removal. Using such tools can scratch the bore or leave burrs on the seal groove edges.

Removing Piston Seal From Caliper:

3. Using a soft tool such as a plastic trim stick, work the piston seal out of its groove in caliper piston bore. Discard the old seal.
4. Clean the piston bore an drilled passage ways using alcohol or a suitable solvent. Wipe it dry using only a lint-free cloth.

Honing Brake Caliper Piston Bore:

5. Inspect the piston bore for scoring or pitting. Bores that show light scratches or corrosion can usually be cleared of the light scratches or corrosion using crocus cloth. Bores that have deep scratches or scoring should be honed. Use Caliper Hone, Special Tool C-4095, or the equivalent to hone the bore. Do not over-hone the bore. Do not increase the diameter of the bore more than 0.0254 mm (0.001 inch). If the bore does not clean up within this specification, a new caliper housing should be installed.

NOTE: During the honing procedure, coat the stones and bore with brake fluid. After honing the bore, carefully clean the seal and boot grooves with a stiff non-metallic rotary brush. Use extreme care in cleaning the caliper after honing. Remove all dirt and grit by flushing the caliper bore with fresh clean brake fluid; wipe it dry with a clean, lint free cloth and then clean it a second time.

6. Inspect the caliper piston for pitting, scratches, or any physical damage. Replace the piston if there is evidence of scratches, pitting or physical damage.