Enable/Disable Horn Chirp

During the programming operation the horn chirp can be disabled or enable using the following procedure. One or both transmitters can be program to be disabled or enable.
1. Retrieve the programming line from the upper edge of the passenger side cowl trim panel upper edge. The RKE Programming Line is a green wire with a red bullet connector.
2. Using a jumper wire, ground the RKE programming line.
3. Turn ignition switch to the ON position.
4. Press any button on the transmitter. The locks will cycle to confirm programming.
5. To disable or enable horn chirp press the lock button on the transmitter four times and the horn will sound to confirm programming. Press the lock button on the second transmitter four times and the horn will sound to confirm programming.
6. Disconnect the programming line from ground.This returns the system to its normal operation mode.
7. Replace any removed components. Return programming line to its original position. Check for system operation.

Panic Function Cancellation
During the programming operation the panic function can be disabled or enable using the following procedure. One or both transmitters can be program to be disabled or enable.
1. Retrieve the programming line from the upper edge of the passenger side cowl trim panel. The RKE Program Line is a green wire with a red bullet connector.
2. Using a jumper wire, ground the RKE Programming Line.
3. Turn ignition switch to the ON position.
4. Press any button on the transmitter. The locks will cycle to confirm programming.
5. To disable or enable panic function press the panic button on the transmitter four times and the horn will sound to confirm programming. Press the panic button on the second transmitter four times and the horn will sound to confirm programming.
6. Disconnect the programming line from ground.This returns the system to its normal operation mode.
7. Replace any removed components. Return the programming line to its original position. Check for system operation.