Washer Reservoir

The content of this article reflects the changes called out by TSB 26-03-99.

REMOVAL

Negative Battery Cable Remote Terminal:

1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Remove the left headlamp assembly and set aside.

Washer Reservoir Removal:

3. Remove the four retaining bolts to the washer reservoir.
4. Disconnect the pump and sensor wire connectors.
5. Disconnect the washer hose.
6. Disconnect the washer filler hose.
7. Pivot the inboard side of the reservoir forward and lift out of vehicle.




8. If replacing the reservoir, you must transfer the pump and sensor to the new reservoir.

NOTE: When transferring pump and sensor, make sure to use a new grommet for proper sealing and to avoid leaks.

INSTALLATION
1. Connect washer hose, filler tube, and wire connectors to reservoir.
2. Install reservoir retaining bolts. Torque bolts to 80 - 124 in. lbs. (9 - 14 Nm).
3. Reconnect the negative battery cable remote terminal.