Windshield Washer Pump: Service and Repair

The content of this article reflects the changes called out by TSB 26-03-99.

REMOVAL

Negative Battery Cable Remote Terminal:

1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Hoist vehicle.
3. Disconnect the washer hose from pump and drain washer solvent into container.
4. Disconnect the wire connectors from the reservoir pump.




5. Gently pry pump away from reservoir and out of grommet. Care must be taken not to puncture reservoir.
6. Remover rubber grommet from reservoir and throw away.

INSTALLATION
For installation, reverse the above procedures. Use new rubber grommet with new pump. Assure pump is fully seated into reservoir.

NOTE: Replace/refill washer fluid after reservoir pump replacement.