System Specifications

Crossover Cable Adjustment Screw 8 Nm (70 inch lbs.)
Dust Shield To Transaxle 12 Nm (105 inch lbs.)
End Plate Cover Bolts 29 Nm (21 ft. lbs.)
Front Engine Mount to Trans 108 Nm (80 ft. lbs.)
Front Mount Through Bolt 61 Nm (45 ft. lbs.)
Front Mount to Engine Bolt 54 Nm (40 ft. lbs.)
Lateral Bending Strut to Engine 54 Nm (40 ft. lbs.)
Lateral Bending Strut to Trans 54 Nm (40 ft. lbs.)
Left Mount Through Bolt 108 Nm (80 ft. lbs.)
Left Mount to Transaxle 54 Nm (40 ft. lbs.)
Output Bearing Race Ret. Strap 11 Nm (96 inch lbs.)
Power Hop Damper Bracket to Transaxle 54 Nm (40 ft. lbs.)
Power Hop Damper to Frame Bracket 54 Nm (40 ft. lbs.)
Power Hop Damper to Trans. Bracket 54 Nm (40 ft. lbs.)
Reverse Fork Bracket 11 Nm (96 inch lbs.)
Reverse Idler Shaft Bolt 26 Nm (19 ft. lbs.)
Shift Cable Bracket to Transaxle 28 Nm (250 inch lbs.)
Transaxle Case Bolts 29 Nm (21 ft. lbs.)
Transaxle to Engine Bolt 95 Nm (70 ft. lbs.)
Transaxle to Engine Intake Bracket Bolts 95 Nm (70 ft. lbs.)
Vehicle Speed Sensor 7 Nm (60 inch lbs.)
Vertical Bending Strut to Engine 108 Nm (80 ft. lbs.)
Vertical Bending Strut to Trans 108 Nm (80 ft. lbs.)

NOTE: Bolts that have thread sealer or torque lock patches should not be reused. Always install new bolts in these applications.