Jumper Harness Procedures - As Required

1. Raise the hood and disconnect the negative battery cable.

2. Raise the vehicle on a suitable hoist.





3. Locate the left (drivers' side) black fan motor connector. Retract the red latch on the two-way female connector, depress the thumb latch, and disconnect the connector from the tan (Figure 1). If the wiring to the fan motor is clipped into the tan support, gently pry it out of the hole so the fan is not damaged.

4. Pry out the two push retainers located on the lower radiator enclosure reinforcement.

5. Install the jumper wire assembly (p/n 05293157AA) between the radiator fan and the headlamp and dash harness:





A. Attach the black two-way male connector with the clip into the outboard hole, so the connector faces outboard toward the left side of the vehicle. Attach the second clip into the inboard hole of the lower reinforcement that the original wiring came out of (Figure 2).

B. Connect the original two-way black connector to the new mating connector installed in the previous step and slide the red latch into the locked position.

6. Connect the two-way female black connector on the new jumper assembly to the fan connector and slide the red latch into the locked position. If the original wiring to the fan was clipped into the fan support, snap the new clip on the jumper into the same hole.

7. Bundle the excess original fan wiring and tie strap to the main bundle of vehicle wiring in the front left corner in two places.

NOTE:
ENSURE THAT THE WIRING BUNDLE IS SECURE AND DOES NOT INTERFERE WITH ANY OTHER COMPONENTS.