Vehicle Speed Sensor: Service and Repair

Fig. 24 Vehicle Speed Sensor:

Fig. 18 Vehicle Speed Sensor -- Manual Transmission:

Fig. 7 Vehicle Speed Sensor And Connector:

Fig. 8 Vehicle Speed Sensor And Speedometer Pinion:

NOTE: When the sensor is removed for any reason, a NEW 0-ring must be installed on its outside diameter.

NOTE: The vehicle speed sensor is located in the transmission extension housing (Fig. 24).

REMOVAL
1. Disconnect electrical connector from sensor.
2. Remove the sensor mounting bolt.
3. Lift the sensor out of the transaxle extension housing. Ensure the 0-ring was removed with the sensor.

NOTE: The speed sensor gear meshes with a gear on the output shaft.

INSTALLATION
1. With 0-ring in place, install sensor and seat sensor by hand -- to ensure proper gear engagement.
2. Install mounting bolt and torque bolt to 2.2 Nm (20 in lb).
3. Connect electrical connector to sensor.