Manifold Pressure/Vacuum Sensor: Service and Repair

MAP/IAT Sensor:

NOTE: The MAP/IAT sensor attaches to the intake manifold plenum.

REMOVAL
1. Disconnect the electrical connector from the MAP/IAT sensor.
2. Remove sensor mounting screws.
3. Remove sensor

INSTALLATION
1. Insert sensor into intake manifold while making sure not to damage 0-ring seal.
2. Tighten mounting screws to 2 Nm (20 in lb) torque for plastic manifold and 3 Nm (30 in lb) for aluminum manifold.
3. Attach electrical connector to sensor.