Removal

CAUTION: Cap all open ends of hoses, power steering pump fittings and steering gear ports to prevent entry of foreign material into the components.

WARNING: Power steering oil, engine parts and exhaust system may be extremely hot if engine has been running. Do not start engine with any loose or disconnected hoses. Do not allow hoses to touch hot exhaust manifold or catalyst.

1. Raise vehicle.





2. Remove bolt attaching power steering hose routing bracket to front suspension crossmember.





3. Disconnect power steering pressure hose at power steering gear. Drain power steering fluid from power steering pump and hose through open end of hose.





4. Remove power steering pressure hose from routing clip on generator shield.
5. Lower vehicle.





6. Remove bolt, attaching power steering pressure hose routing clip, to generator shield.





7. Loosen and remove Banjo bolt, and power steering pressure hose from pressure fitting on power steering pump.
8. Power steering fluid pressure hose is removed from the vehicle from the top of the engine compartment.
9. Discard all used O-rings located at ends of power steering pressure hose and Banjo bolt.