Installation

1. Position engine and transmission assembly under vehicle and slowly lower the vehicle over the engine and transmission.
2. Align engine and transmission mounts to attaching points. Install mounting bolts at the right engine and left transmission mounts.
3. Remove safety straps from engine and transmission assembly. Slowly raise vehicle enough to remove the engine dolly and cradle.
4. Install axle shafts.
5. Install transmission and engine braces and splash shields.
6. Connect exhaust system to manifold.
7. Install power steering pump and reservoir.
8. Install A/C compressor and hoses.
9. Install accessory drive belts.
10. Install front engine mount.
11. Manual transmission: Install power hop damper.
12. Install inner splash shield. Install wheels and tires.
13. Manual Transmission: Connect clutch cable and linkages.
14. Automatic Transmission: Connect shifter and kickdown linkage.
15. Connect fuel line and heater hoses.
16. Install ground straps. Connect engine and throttle body connections and harnesses.
17. Connect throttle body linkage.
18. Install radiator and shroud assembly. Install radiator hoses. Fill cooling system.
19. Install battery tray and battery. Set Powertrain Control Module (PCM) into place.
20. Install air cleaner and hoses.
21. Install oil filter. Fill engine crankcase with proper oil to correct level.
22. Perform camshaft and crankshaft timing relearn procedure as follows:
- Connect the DRB scan tool to the data link (diagnostic) connector. This connector is located in the passenger compartment; at the lower edge of instrument panel; near the steering column.
- Turn the ignition switch on and access the "miscellaneous" screen.
- Select "re-learn cam/crank" option and follow directions on DRB screen.
23. Start engine and run until operating temperature is reached.
24. Adjust transmission linkage, if necessary.