A. Install the Jumper Harness

1. With the ignition key in the OFF position, disconnect the battery.

Note:
To enhance customer satisfaction, remember to record all radio settings before disconnecting the battery and to reset all electronic memory (clock, radio settings, etc.) when you have completed the service procedure.

2. Raise the vehicle on an appropriate hoist.





3. Disconnect the left (driver side) black fan motor electrical connector by retracting the red latch and depressing the thumb latch (Figure 1).

4. Disconnect the fan motor wiring harness connector from the fan support (if necessary).

5. Disconnect the two (2) push-in fasteners that secure the radiator fan section of the main electrical harness to the lower radiator support.





6. Attach the push-in clip on the male connector of the provided jumper harness into the outboard hole in the lower radiator support so that the connector faces toward the outboard (left) side of the vehicle (Figure 2).

7. Attach the other jumper harness clip into the inboard hole in the lower radiator support (Figure 2).

8. Connect the main wiring harness radiator fan electrical connector to its mating connector on the jumper harness. Slide the red latch to the locked position.

9. Connect the other end of the jumper harness to the fan motor harness. Slide the red latch to the locked position.

10. Bundle the excess fan wiring and secure it to the main wiring harness with the two (2) provided tie straps.

NOTE:
Make sure that the wiring does not interfere with any other components.