Parking Brake Shoe: Service and Repair

REMOVE
1. Remove rear disc brake caliper assembly from adapter and rotor.
2. Remove rear rotor from rear hub.
3. Remove dust cap from rear hub.
4. Remove rear hub and bearing assembly retaining nut and washer.
5. Remove rear hub and bearing assembly from rear spindle.

Rear Brake Shoe Hold-Down Clip:

6. Remove rear brake shoe assembly hold down clip.
7. Turn brake shoe adjuster wheel until adjuster is at shortest length.

Park Brake Shoe Adjuster Assembly:

8. Remove adjuster assembly from the parking brake shoe assemblies.

Brake Shoe Lower Return Spring:

9. Remove lower shoe to shoe spring.

Brake Shoe And Upper Spring:

10. Pull rear brake shoe assembly away from anchor. Then remove rear brake shoe and upper spring.

Front Hold Down Clip And Brake Shoe:

11. Remove front brake shoe hold-down clip. Then remove front brake shoe assembly.

INSTALL
1. Install front brake shoe and hold down clip.
2. Install rear brake shoe and the upper brake shoe to shoe return spring.
3. Pull rear brake shoe over anchor block until properly located on adapter.
4. Install the lower shoe to shoe return spring.
5. Install brake shoe adjuster assembly with star wheel rearward.
6. Install rear brake shoe hold down clip.
7. Adjust brake shoes to a diameter to 171 mm (6.75 inch).
8. Install rear hub and bearing assembly on spindle.
9. Install A NEW hub and bearing assembly retaining nut. Torque the hub and bearing assembly retaining nut to 168 Nm (124 ft. lbs.).
10. Install hub and bearing assembly dust cap.
11. Install rear rotor.
12. Install rear disc brake caliper on the adapter.
13. Install wheel and tire assemblies.
14. Tighten wheel stud nuts to 129 Nm (95 ft.lbs.).