Shift Cable: Adjustments

The gearshift selector cable is not adjustable. If adjustment is required, only the crossover cable may be adjusted.
1. Remove gearshift console from vehicle.

Gearshift Crossover Cable Adjustment:

2. Loosen crossover cable adjustment screw.

Crossover Lever Attachment To Transaxle:

3. Using a 1/4 inch drill bit or suitable equivalent, pin crossover cable lever to transaxle. Ensure drill bit engages through crossover lever into transaxle case at least one half inch.
4. Ensure shift lever is in the spring loaded neutral position. If necessary, move lever forward and back, then allow lever to fall into it's natural neutral position.
5. Without allowing movement in either cable or lever, hand tighten crossover cable adjustment screw, then tighten screw to specifications.
6. Remove pin from transaxle crossover lever, then check transaxle shift functions.
7. Install gearshift console.