Electronic Brake Control Module: Service and Repair

Controller Antilock Brake:

REMOVE
1. Turn vehicle ignition off.

CAB 60-Way Wiring Harness Connector:

2. Disconnect the wiring harness 60 way connector from the Controller Antilock Brake Module (CAB). Verify that the vehicle ignition is off before removing the 60 way connector.

CAB Bracket To Kick Panel Mounting:

3. Remove the 2 controller bracket to drivers side cowl mounting nuts.
4. Remove the CAB from the vehicle.

INSTALL
1. Install CAB and mounting bracket on mounting studs located on passenger side kick panel.
2. Install the 2 CAB bracket mounting nuts and securely tighten.
3. Install the 60-way wiring harness connector by hand into the 60-way CAB connector, as far as possible. Then use the CAB connector retaining bolt to fully seat wiring harness connector into the CAB.
4. Torque the 60-way connector retaining bolt to 4 Nm (38 inch lbs.).
5. If a new CAB is being has been installed, it must be initialized prior to the vehicle being driven. The CAB is initialized using the DRB Scan Tool and the initializing procedure described upon selecting Bendix ABX-4 Diagnostics. New controllers are programmed to flash the ABS warning lamp until initialized by the installing technician.