2 Door Models

NOTE: Power and manual door glass regulators are serviced using the same procedures. For power window motor service procedures, refer to Power Window Motor/Service and Repair.

REMOVAL
1. Remove door trim panel and water shield. refer to Door Panel/Service and Repair.
2. Disconnect wire connector to power window motor, if so equipped.

Regulator Lift Channel:

3. Remove nuts holding regulator lift channel to door glass.
4. Secure door glass in upward position.
5. Mark position of rear bolt of roller channel to inner door panel to aid in installation.
6. Remove bolt holding rear of roller channel to door panel.
7. Loosen bolt holding front of roller channel to door panel.

Roller Channel:

8. Separate roller channel from door panel.
9. Loosen bolts holding window regulator to inner door panel.
10. Separate bolt heads from key-hole slots in inner door panel.

Manual Window Regulator:

Power Window Regulator:

11. Remove window regulator through large hole in inner door panel.
12. Remove power window motor from regulator, if so equipped. Refer to Power Window Motor/Service and Repair.

INSTALLATION
1. Install power window motor on regulator, if so equipped. Refer to Power Window Motor/Service and Repair.
2. Move window regulator into position in door and engage bolt heads into key-hole slots in inner door panel and tighten bolts.
3. Install roller channel to door panel.
4. Install bolt at rear of roller channel. Make sure that bolt is aligned to mark on inner door panel made previously
5. Tighten front and rear bolts of roller channel.
6. Install nuts holding regulator lift channel to door glass.
7. Adjust door glass as described in this section.
8. Connect wire connector to power window motor, if so equipped.
9. Install door speaker, if so equipped.
10. Install door trim panel and water shield.