Drive Belt - Momentary Loss of Power Steering Assist
NO: 07-04-97GROUP: Accessory Belt
DATE: Jun. 6, 1997
SUBJECT:
Momentary Loss Of Power
Steering Assist When
Driving Through Heavy
Rain - Deep Puddles
MODELS:
1995 - 1997 (PL) Neon
SYMPTOM/CONDITION:
Momentary loss of power steering assist when driving through heavy rain and/or deep puddles. Loss of power steering is caused by water intrusion into the accessory drive belt area.
DIAGNOSIS:
Inspect the belt for glazing and/or cracks, if either is found replace the belt following the repair procedure found in the 1997 Neon Service Manual (Publication No. 81-270-7025) Page 7-21. Determine the road conditions the driver of the vehicle was encountering at the time the loss of power assist was experienced. If the driver indicates the loss of power steering assist was during times of heavy rain or deep puddles, perform the Repair Procedure.
PARTS REQUIRED:
AR(1) 04612247 Belt, Accessory Drive - Power steering and A/C Compressor
REPAIR PROCEDURE:
This bulletin involves correcting the tension on the power steering accessory drive belt.
1. Loosen the power steering pump locking bolts A and B and pivot bolt C (Illustration) to allow adjustment of belt tension.
2. Using a 1/2" breaker bar, adjust belt tension by applying torque to the square hole "D" on the power steering pivot bracket. Adjust the tension as follows:
Belt tension with no belt replacement:
A. Using the Belt Tension Gauge Special Tool Kit C-4162, adjust the belt tension to 100 lb.
B. Tighten in order, first tighten the locking bolt A to 27 Nm (20 ft. lbs) then, bolt B to 27 Nm (20 ft. lbs). Finally tighten the pivot bolt C to 54 Nm (40 ft. lbs).
Belt tension with belt replacement:
A. Using the Belt Tension Gauge Special Tool Kit C-4162, adjust the belt tension to 135 lb.
B. Tighten in order, first tighten the locking bolt A to 27 Nm (20 ft. lbs) then, bolt B to 27 Nm (20 ft. lbs). Finally tighten the pivot bolt C to 54 Nm (40 ft. lbs).
C. Start the engine and allow the vehicle to idle for 15 minutes to allow the belt to seat.
D. Repeat the belt tensioning procedure, set belt tension to 135 lb.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No: 07-20-11-90 0.2 Hrs.
FAILURE CODE: XX - Service Adjustment