Sunroof Open/Close

CIRCUIT OPERATION
When the operator selects sunroof OPEN the switch connects the feed circuit F10 to circuit Q41. The Q41 circuit connects from the switch to the OPEN side of the motor.

Ground for the motor is supplied on circuit Q42 from the motor back to the CLOSE side of the open/close switch. The ground is passed through the bus bar in the switch to circuit Q45. Circuit Q45 connects from the open/close switch to the tilt switch.

The ground is passed through the switch to circuit Z5 and finally to ground.

When the operator selects the CLOSE function, power and ground are reversed.