Sling-Well Removal

1. Remove rear seat cushion and back.
2. Remove quarter trim panels.
3. Remove rear shoulder harness turning loop covers.
4. Remove bolts holding shoulder harness turning loops to seat back support.
5. Remove seat back support trim cover.
6. Disengage wire hanger from hole in quarter panel near front seat belt retractor.
7. Disengage convertible top header latches.
8. From in luggage compartment, remove nuts and bolts holding lower top tack strip to deck and quarter panels. Lift sling well upward to gain access to fasteners.

CAUTION: Do not damage painted surfaces when separating tack strip from mounting locations.

9. Separate tack strip from deck and quarter panels and remove staples holding sling well and top cover to tack strip.
10. Separate sling well from vehicle.
11. Reverse the preceding operation for installation. Use a suitable contact adhesive to secure sling well to seat back support and wherever necessary