Fuel Filter: Service and Repair

Fuel Filter:

WARNING: The fuel system is under constant pressure, even when the engine is OFF. Always release fuel pressure before servicing any fuel system component.

REMOVAL

1. Release fuel system pressure.
2. Disconnect the negative battery cable.
3. Raise, and support the vehicle for access.
4. Remove fuel filter hoses and clamps from the inlet and outlet fuel lines. Remove mounting bracket bolt, and remove filter.

INSTALLATION

1. Install the new filter assembly on the mounting plate. Check the direction of flow by the markings on the filter, and ensure it is correct.
2. Install the mounting bolt, and torque to 8 Nm (75 in-lbs)
3. Install the inlet and outlet hoses, and clamps. Tighten the clamps securely. Lower the vehicle. Connect negative battery cable.
4. Using scan tool [1], activate fuel pump and pressurize system.
5. Check for leaks.

Remarks

[1] Follow scan tool manufacturer's instructions.