Connector Replacement

1. Disconnect battery.
2. Disconnect the connector that is to be repaired from its mating half.

Connector Locking Wedge Tab:

3. Remove connector locking wedge.

Connector Locking Finger And Locking Wedge:

4. Position the connector locking finger away from the terminal. Pull on the wire to remove the terminal from the connector.
5. Reset the terminal locking tang, if it has one.
6. Insert the removed wire in the same cavity on the repair connector.
7. Repeat steps four thru six for each wire in the connector, being sure that all wires are inserted into the proper cavities. For additional connector pin out identification refer to the wiring diagrams.
8. Insert the connector locking wedge into the repaired connector.
9. Connect connector to its mating half.
10. Connect battery and test all affected systems.