Fuel Injector Test

1. Ensure fuel pressure is within specifications. If pressure is not within specifications.
2. If pressure is within specifications connect a tachometer and start the vehicle. Disconnect one injector wiring connector at a time and observe engine rpm. If there is no change in rpm when an injector is disconnected this injector is not operating properly.
3. Connect a "noid" light to the injector connector. Turn engine over and observe the light , if the light flashes proceed to step 8.
4. If the light does not flash check the injector circuit. Fuel Injector Electrical Circuit Diagnosis
5. Remove suspect injector and inspect the inlet for blockage. If the inlet is blocked replace the injector.
6. If the injector is not plugged inspect the fuel rail for restriction. Clear blockage or replace fuel rail.
7. Connect a 12 volt source to one terminal of the injector and momentarily connect a ground to the other terminal. If a distinct click is not heard when the ground is applied replace the injector.