Overdrive Switch - Removal Procedure
90chrysler10 Models1984-1988 YDC 1987-1988 SJ,LC 1989-1990 B2,B5,B6
Subject
Automatic Transmission Overdrive Switch Removal Procedure
Index
TRANSMISSION
Date
August 13, 1990
No.
21-18-90
P-2317 (C21-14-0)
BODY CODE LEGEND
YDC/B5 - CONQUEST SJ/B6 - RAIDER LC/B2 - COLT
DISCUSSION
To prevent damaging the overdrive (0D) transmission selector knob when removing the overdrive switch, the following procedure should be followed:
Figure 1:
PROCEDURE
1. Remove the transmission selector knob as outlined in the appropriate service manual.
2. Place the 0D switch in the "OFF" position, (the switch button protrudes).
3. Using a small flat blade screwdriver gently pry the button loose as shown in Figure 1.
4. Holding the OD switch plunger in the depressed (ON) position carefully remove the OD switch from the selector knob, Figure 2.
5. To install the switch reverse the procedure.
POLICY: Information only.