Windshield Washer Pump - Installation

DIESEL ENGINE






1. Install a new rubber grommet seal/filter screen into the washer pump mounting hole in the washer reservoir (3). Always use a new rubber grommet seal/filter screen on the reservoir.

2. Reconnect the reservoir washer hose to the barbed pump outlet nipple of the washer pump/motor unit (2).

3. Position the inlet nipple on the base of the pump housing of the washer pump/motor unit to the rubber grommet seal/filter screen in the reservoir.

4. Using hand pressure, press firmly and evenly downward on the top of washer pump/motor unit until the inlet nipple is fully seated in the rubber grommet seal/filter screen in the pump mounting hole of the reservoir.

5. Align the top of the washer pump/motor unit housing with the receptacle in the washer reservoir.

6. Using hand pressure, press firmly and evenly on the top of washer pump/motor unit until the housing snaps into the receptacle.

7. Reconnect the Front End Module (FEM) wire harness connector (6) to the washer pump/motor unit connector receptacle at the top of the motor housing.

8. Reinstall the splash shield into the front fender (1) wheel housing of the vehicle. Splash Shield - Installation.

9. Refill the washer reservoir with the washer fluid drained from the reservoir during the removal procedure.

10. Reconnect the battery negative cable.