Front - HD

FRONT - HEAVY DUTY

NOTE:
Install a new copper washers on the banjo bolt when installing

1. Install the disc brake caliper.

CAUTION:
Verify that the brake hose is not twisted or kinked before tightening the fitting bolt.

2. Install the banjo bolt with new copper washers to the caliper. Tighten to 27 Nm (20 ft. lbs.)

3. Install the caliper slide pin bolts. tighten to 32 Nm (24 ft. lbs.)

4. Remove the prop rod from the brake pedal.

5. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performed..

6. Install the tire and wheel assembly .

7. Remove the supports and lower the vehicle.