Wheel Stud - Installation

REAR






1. Install the new stud (4) into the hub flange (2) at the opening where the adjuster was removed.

2. Install three proper sized washers (1) onto the new stud (4), then install a lug nut (3) with the flat side of the nut against the washers.

3. Tighten the lug nut (3) until the stud (4) is pulled into the hub flange (2). Verify that the stud is properly seated into the flange.

4. Remove the lug nut (3) and washers (1).





5. Install the parking brake adjuster (2) between the parking brake shoes (1) with the adjuster star wheel near the adjustment window in the brake shield.

6. Using appropriate tools, install the spring (3) at the adjuster (2).

7. Adjust parking brake shoes as necessary, .

8. Install the brake rotor, caliper adapter and caliper, .

9. Using a new lug nut on the new stud, install the wheel and tire assembly, .

10. Remove the supports and lower the vehicle.