Installation

4X2

Special Tools:











NOTE:
Upper shock nut must be replaced or use Mopar Lock 'N Seal or Loctite(R) 242 on existing nut.

1. Install the lower retainer and grommet on the shock absorber stud. Insert the shock absorber through the frame bracket hole.

2. Install the lower bolts and tighten the bolts to specifications .

3. Install the upper grommet, retainer (2) and new nut or use Mopar Lock 'N Seal or Loctite(R) 242 on existing nut, on the shock absorber stud. Using Strut Nut Wrench (9362) (1), tighten nut to specifications .

4. Remove the support from the lower control arm outboard end.

5. Remove the support and lower the vehicle.