Installation

INSTALLATION

EXTERNAL TRANSMISSION COOLER





1. Position the transmission cooler tubes to the front of the radiator by sliding brackets into slots on radiator inlet tank.
2. Snap the transmission cooler tubes into the clips on the side of the radiator tank.
3. Install the transmission cooler attaching bolt. Tighten the bolt to 16 Nm (140 in. lbs.).
4. Inspect the quick connect fittings for debris and install the quick connect fitting on the cooler tube until an audible "click" is heard. Pull on the connection to verify proper installation and install the secondary latches, .
5. Start the engine and check all fittings for leaks.
6. Check the fluid level in the automatic transmission.

A/C CONDENSER/TRANSMISSION COOLER





NOTE: The transmission cooler is integrated in with the A/C condenser.

1. The A/C condenser/transmission cooler is removed as an unit A/C Condenser - Installation.
2. Top off the transmission oil to the required level.
3. Take vehicle for test to ensure all the air has escaped from the cooler.
4. Recheck the transmission oil.