Installation

4X4-COIL OVER

NOTE: All suspension components should be tighten with the weight of the vehicle on them (curb height).





1. Install the shock (1) back in place in the vehicle.





2. Install the upper part of the shock (2) into the frame bracket (3).
3. Install the upper nuts (1) and tighten to specifications .





4. Install the lower part of the shock (5) into the lower control arm shock bushing (7).
5. Install and position bolt (6) so head of bolt is facing rearward of vehicle and hand start nut. Tighten the bolt (6) and nut to specifications .
6. Install the upper ball joint to the knuckle and install the retaining nut and tighten to specifications .
7. Install the axle hub nut and tighten to specifications .
8. Install the stabilizer link lower nut and tighten to specifications .

9. Reconnect the wheel speed sensor wiring to the knuckle and upper control arm.
10. Install the rotor Brake Rotor - Installation.
11. Install the caliper adapter with the caliper Disc Brake Caliper Adapter - Installation.
12. Remove the support from the lower control arm outboard end.
13. Install the tire and wheel assembly Service and Repair.
14. Remove the support and lower the vehicle.