Independent Front Suspension

INSTALLATION





1. Position the control arm (1) into the frame brackets. Install bolt (3) and nut (2), and tighten to specifications .





2. Insert the ball joint in the steering knuckle (3) and tighten the upper ball joint nut (2) to specifications .
3. Install the rotor to the hub.
4. Install the disc brake caliper and adapter to the knuckle Disc Brake Caliper Adapter - Installation.
5. Install the wheel speed sensor wire to the upper control arm.
6. Install the wheel and tire assembly Service and Repair.
7. Remove the support and lower vehicle.
8. Perform a wheel alignment Service and Repair