Independent Front Suspension

REMOVAL

Special Tools:






NOTE: The steering column on vehicles with an automatic transmission may not be equipped with an internal locking shaft that allows the ignition key cylinder to be locked with the key. Alternative methods of locking the steering wheel for service will have to be used.





1. Lock the steering wheel.
2. Drain and siphon the power steering fluid from the reservoir.
3. Raise and support the vehicle.
4. Remove and discard the steering coupler pinch bolt.
5. Disconnect the power steering hoses from the rack and pinion (2).
6. Remove the front tires and wheels.
7. Remove the outer tie rod nuts and separate outer tie rods (3) from the knuckles (5) using Ball Joint Remover Tie Rod End - Removal.










NOTE: 4wd model shown. 2wd model similar.

8. If equipped, remove the skid plate Front.
9. Remove the rack and pinion mounting bolts (2) and remove the rack from the vehicle.