Steering Damper Bracket, Link And Coil - Installation

BRACKET - 2500/3500

NOTE: All views are typical.





1. NOTE: Some brackets may have the steering damper retaining bolt permanently attached to the bracket.
Place the steering damper retaining bolt (7) in the bracket (3) and position the bracket on the flat of the linkage.
2. With the bracket (3) centered on the flat of the linkage, position the u-bolts (2) over the linkage, through the bracket and install the four (or two) u-bolt nuts (5). Do not tighten at this time.
3. Verify the bracket (3) is centered in the flat area of the linkage and tighten the four (or two) u-bolt nuts (5) to specifications [1][2]Specifications.
4. Position the steering damper (1) on the retaining bolt (7).
5. Install the steering damper retaining nut (6) and tighten to specifications [1][2]Specifications.
6. Remove the support and lower the vehicle.