Installation

INSTALLATION

NOTE: All views are typical.






CAUTION: The ball joint stud tapers must be CLEAN and DRY before installing the knuckle. Clean the stud tapers with a clean cloth to remove dirt and grease.

NOTE: When installing hub/bearing with ABS brakes, position the speed sensor opening towards the front of the vehicle.

1. Install the brake dust shield and hub/bearing to the steering knuckle (1) and tighten the 3 bolts to specifications Front Suspension Specifications
2. Install the knuckle (1) onto the upper and lower ball joints.
3. Install the upper and lower ball joint nuts and tighten to specifications .
4. Remove the hydraulic jack from the lower control arm (4).






NOTE: If a new tie rod end is to be installed, make sure the boot (2) is properly lubricated.

5. Clean all old grease and debris from the boot (2) with a clean cloth.
6. Apply outer tie rod grease P/N 68088623AA (1) to the tie rod end boot (2).
7. Install the tie rod end and tighten the nut to specifications

8. Install the front halfshaft into the hub/bearing (if equipped).
9. Install the halfshaft nut (if equipped) and tighten to specifications .
10. Install the ABS wheel speed sensor (if equipped) Front and brake shield, rotor and caliper Brake Rotor - Installation.
11. Install the wheel and tire assembly Service and Repair.
12. Remove the support and lower the vehicle.
13. Perform a wheel alignment Service and Repair