To Knuckle

TO KNUCKLE

NOTE: All views are typical.





1. Install the drag link end to the adjustment sleeve (1).





2. Install the drag link (3) to knuckle (5). pitman arm nut (5) or drag link to tie rod nut (10) as necessary and tighten to specifications [1][2]Specifications.
3. Install the drag link/tie rod to knuckle nut (2) and tighten to specifications [1][2]Specifications.
4. Install the cotter key (1).





5. Remove the supports and lower the vehicle. Center the steering wheel and adjust the toe Service and Repair.

NOTE: Position the clamp on the adjustment sleeve (1) so retaining bolt is located on the bottom side of the sleeve.

6. After adjustment tighten tie rod adjustment sleeve clamp bolts (2) to specifications, [1][2]Specifications.