Right Hand to Tie Rod

RH - TO TIE ROD

NOTE: All views are typical.





1. Install the drag link end (2) to the adjustment sleeve (3) and to the tie rod (6).
2. Install the drag link to tie rod nut (10) and tighten to specifications [1][2]Specifications.
3. Remove the supports and lower the vehicle. Center the steering wheel and adjust the toe Service and Repair

NOTE: Position the clamp on the adjustment sleeve so retaining bolt is located on the bottom side of the sleeve.

4. After adjustment, tighten drag link adjustment sleeve clamp bolts to specifications, [1][2]Specifications.