Glove Box Lamp/Switch - Installation

LAMP/SWITCH

WARNING: To avoid serious or fatal injury on vehicles equipped with air bags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Position the glove box lamp and switch unit (4) into the upper glove box bin (1).
2. Reconnect the instrument panel wire harness connector (3) to the switch connector receptacle.
3. Feed the wire harness back through the switch mounting hole of the upper glove box bin.
4. Align the lamp and switch unit with the mounting hole in the bin.
5. Using hand pressure, push the lamp and switch unit firmly and evenly into the mounting hole until it is fully seated and both retaining latches (5) are engaged.
6. Close the upper glove box door.
7. Reconnect the battery negative cable.