Power Brake Booster - Installation

INSTALLATION










1. Guide the booster (2) studs into the cowl panel holes and seat the booster on the panel.
2. Install and tighten the new booster attaching nuts (1) to 28 Nm (250 in. lbs.).
3. Install the booster push rod on the brake pedal and install clip.
4. Install the brake lamp switch Stop Lamp Switch - Installation.
5. Install the booster check valve if removed and connect the vacuum hose to the check valve.
6. Install the master cylinder Brake Master Cylinder - Installation.
7. Fill and bleed the brake system Service and Repair.