Hydro-boost Power Brake Booster - Removal

REMOVAL






NOTE: If the booster is being replaced because the power steering fluid is contaminated, flush the power steering system before replacing the booster.

1. With engine off depress the brake pedal 5 times to discharge the accumulator.
2. Remove brake lines (5) from master cylinder (3).
3. Remove mounting nuts (4) from the master cylinder.
4. Remove the master cylinder (3).
5. Remove the return hose and the two pressure lines (2) from the hydraulic booster.
6. From inside the vehicle remove the booster push rod clip, washer and rod remove from the brake pedal.
7. Remove the brake lamp switch Stop Lamp Switch - Removal.
8. Remove the mounting nuts from the hydraulic booster and remove the booster.