Hydro-boost Power Brake Booster - Installation

INSTALLATION





1. Install the hydraulic booster and tighten the mounting nuts to 28 Nm (21 ft. lbs.).
2. Install the booster push rod, washer and clip onto the brake pedal.
3. Install the brake lamp switch Stop Lamp Switch - Installation.
4. Install the master cylinder on the mounting studs and tighten the mounting nuts (4) to 23 Nm (17 ft. lbs.).
5. Install the brake lines (5) to the master cylinder (3) and tighten to 19 Nm (170 in. lbs.).

NOTE: Inspect the o-rings on the pressure line fittings to insure they are in good condition before installation. Replace the o-rings if necessary.

6. Install the hydraulic booster pressure lines (2) to the booster and tighten to 41 Nm (30 ft. lbs.).
7. Install the return hose to the booster.
8. Bleed the base brake system Service and Repair.

CAUTION: MOPAR (MS-9602) ATF+4 is to be used in the power steering system. No other power steering or automatic transmission fluid is to be used in the system. Damage may result to the power steering pump and system if any other fluid is used, and do not overfill.

9. Fill the power steering pump with fluid, Procedures
10. Bleed the hydraulic booster Procedures.