Hydroboost

HYDROBOOST





1. Remove the brake lines (5) from the master cylinder (3).
2. Disconnect the electrical connector (1) for the low fluid level.
3. Remove the mounting nut (4) from bottom of the master cylinder (3).





4. Unclip the wiring box (3) next to the master cylinder (4) and move out of the way.
5. Remove the upper mounting nut (2) for the master cylinder.

NOTE: Using care remove the master cylinder directly forward in order not to dislodge the output rod from its seat inside the booster.


6. Remove the master cylinder (4).