Brake Pedal

BRAKE PEDAL

NOTE: The views in this procedure are with adjustable pedals. Without adjustable pedals are similar.

NOTE: If equipped with adjustable pedals: When replacing the components both pedal assemblies must be in the fully down position toward the floor for proper adjustment. Pedals can be moved manually by rotating the cable on the component not being replaced. New components come in the correct position until activated.

1. Remove the pedal assembly Brake and/or Accelerator Pedals - Removal.





NOTE: The adjustable pedal motor has three locking tabs (3) that prevent easy twisting when removing drive cable from housing.

2. If equipped with adjustable pedals, disconnect the drive cable (2) from the adjustable pedal motor (5) by twisting clockwise and lifting from motor.






NOTE: If equipped with adjustable pedals, note the spring and bushing positions during removal for proper installation.

3. Remove the e-clip (1) from the brake pedal pivot shaft and slide shaft (2) from the pedal assembly (4).
4. Remove the brake pedal (3) from the pedal assembly (4).