Brake Pedal

BRAKE PEDAL

NOTE: The views in this procedure are with adjustable pedals. Without adjustable pedals are similar.

NOTE: If equipped with adjustable pedals: When replacing the components both pedal assemblies must be in the fully down position toward the floor for proper adjustment. Pedals can be moved manually by rotating the cable on the component not being replaced. New components come in the correct position until activated.






NOTE: The spring is only used if equipped with adjustable pedals.

1. Verify the bushings (1) and spring (2) are installed on the brake pedal (6).
2. Install a bushing (4) and e-clip (5) on the brake pedal pivot shaft (3).





3. Position the brake pedal (3) and slide the pivot shaft (2) through the bracket and brake pedal.






NOTE: If equipped with adjustable pedals, verify the spring is properly positioned.

4. Install the bushing (2) and e-clip (1) to secure the pivot shaft (3).






NOTE: Drive cable to motor housing adapter (2) can be turned manually within the motor housing (1) to allow proper alignment for drive cable attachment to motor.

5. If equipped with adjustable pedals, verify the drive cable to motor housing adapter (2) is properly inserted in motor housing (1) before attaching drive cable.






NOTE: A snap sound should be heard when drive cable locks into position.

6. If equipped with adjustable pedals, align drive cable housing to motor tabs/slots (3), and using light hand pressure push drive cable (2) into position on the drive motor (5). Turn counter clockwise to lock into position.
7. Install the pedal assembly Brake and/or Accelerator Pedals - Installation.