Heater Pad - Installation

INSTALLATION

CAUTION: During the installation of the replacement heating element, be careful not to fold or crease the element assembly. Folds or creases will cause premature failure.

NOTE: Some model vehicles come equipped with both heated and vented seats front seats.






NOTE: On vehicles equipped with vented seats, the vented seat pad will have to be routed through the seat cushion prior to installation of the seat cushion

1. Peel off the adhesive backing from the replacement heater element (2) and stick on foam pad directly where the original heater element was positioned (1). There will be adhesive marks on the cushion outlining the factory installed location.






NOTE: Make certain the seat wire harness is correctly routed through the seat and seat back. The excess wire between the cushion and back elements should be securely tucked between the rear of the cushion foam and the rear seat cover flap.

2. Connect the heater element electrical connectors (3 and 4).
3. Reconnect the negative battery cable.
4. Verify heated seat system operation.
5. Install the appropriate seat cushion or seat back cover.