Front

INSTALLATION

Manual





1. Position the cover (1) onto the foam and install 10 new hog rings (2).





2. Position the foam/cover assembly onto the seat cushion frame and secure the J-straps (1) on the sides.





3. Install the push pin fastener (3) and seat fully.
4. Install the recliner rod (1) and seat the retaining clip (2) fully.





5. Install the outer side shield and seat the clips (2) fully.
6. Install the screw (1).





7. Position the bezel to the outboard side shield and engage the front retaining tab.
8. Seat the remaining tabs (3) fully.
9. Position the recliner handle (1) onto the splined shaft and seat fully.





10. Install the inboard shield (2) and install the screw (1).





11. Install the side shield screws (2) in the back.





12. Secure the seat back cover straps (2) to suspension mat.

Power Without Vented Seat





1. Position the cover (1) onto the foam and install 10 new hog rings (2).





2. Position the foam/cover assembly onto the seat cushion frame and secure the J-straps (1) on the sides.





3. Install the outer side shield and seat the clips (2) fully.
4. Install the screw (1).





5. Connect the wire harness connectors to the power seat switch and memory seat switch, if equipped.
6. Position the bezel (1) back into place and secure the front tab (2).
7. Seat the remaining tabs (3) fully.





8. If equipped, connect the lumbar switch electrical connector (1).





9. Install the inboard shield (2) and install the screw (1).





10. Install the side shield screws (2) in the back.





11. Secure the seat back cover straps (2).
12. Connect the electrical connectors (1).
13. Install the front seat Front Seat - Installation.

Power With Vented Seat





1. Pull the vent pad (1) through the foam.





2. Position the cover (1) onto the foam and install 10 new hog rings (2).





3. Position the foam/cover assembly onto the seat cushion frame and secure the J-straps (1) on the sides.





4. Position the vented seat pad (2) onto the vent motor if equipped, and seat the clips fully.
5. Connect the electrical connectors, if equipped.





6. Install the outer side shield and seat the clips (2) fully.
7. Install the screw (1).





8. Connect the wire harness connectors to the power seat switch and memory seat switch, if equipped.
9. Position the bezel (1) back into place and secure the front tab (2).
10. Seat the remaining tabs (3) fully.





11. If equipped, connect the lumbar switch electrical connector (1).





12. Install the inboard shield (2) and install the screw (1).





13. Install the side shield screws (2) in the back.





14. Secure the seat back cover straps (2).
15. Connect the electrical connectors (1).
16. Install the front seat Front Seat - Installation.