Adjuster Motor

REMOVAL






WARNING: A seat structure that has seen significant load may have the locking mechanism activated and may exhibit the following symptoms:
- Locking pawl (2) loose
- Locking pawl (2) engaged into the seat frame sidemember (1)
- Height adjuster only works on outboard side
- Broken or missing shear pin (3)
If any of above symptoms exist, replace the height adjuster assembly. Do not attempt any repairs. Failure to follow these instructions may result in possible serious or fatal injury.

FRONT TILT MOTOR





1. Disconnect and isolate the negative battery cable.
2. Remove the affected seat Service and Repair.
3. Remove the affected seat cushion cover, cushion and pan.
4. Disconnect the electrical connector from the front tilt motor (1).
5. Remove the screws retaining the front tilt motor to the seat adjuster.
6. Remove the front tilt motor from the seat adjuster.

REAR TILT MOTOR





1. Disconnect and isolate the negative battery cable.
2. Remove the affected seat Service and Repair.
3. Remove the affected seat cushion cover, cushion and pan.
4. Disconnect the electrical connector from the rear tilt motor (3).
5. Remove the screws retaining the rear tilt motor to the seat adjuster.
6. Remove the screw and washer from the motor shaft.
7. Remove the rear tilt motor from the seat adjuster.