Nameplate - Removal

REMOVAL

Special Tools:









Figure 1 - NAME PLATES





NOTE: Standard Cab model shown in the illustration. Exterior name plates and decals for all other cab models are similar. Exterior name plate and decal usage vary by model.

1. As a guide for installation, apply a length of masking tape on the body, parallel to the top edge and, to one end of the name plate or decal being removed.

CAUTION: Do not exceed 52° C (120° F) when heating name plates, decals or body panels. Failure to follow this caution may result in damage to the name plates, decals and/or the vehicle paint finish.

2. If the temperature is below 21° C (70° F), warm the name plate or decal with a heat lamp or heat gun.

NOTE: The exterior name plates are attached to the body with adhesive tape.

3. Using a trim stick or equivalent, carefully remove the name plate or decal from the body panel, as necessary.