Floor Console - Installation

INSTALLATION





1. Position the floor console inside the vehicle and over the support brackets.





2. Connect the power outlet electrical connector, if equipped.
3. Connect the electrical connectors (1, 2 and 3).





4. Position the shift cable back into place and secure the housing to the shifter assembly (1).
5. Seat the cable end onto the shifter stud (2) fully.





6. Position the shift bezel (2) in place and seat the retaining tabs fully.
7. Install the screws (1).





8. Install the shift cable cover (2) and seat the retaining clips fully.
9. Position the trim ring (1) into place and seat the retaining tabs fully.





10. Install the screws (3) and tighten to 7 Nm (62 in. lbs.).
11. Install the screws (1) and tighten to 7 Nm (62 in. lbs.).
12. Install the screws (4).





13. Position the side trim (1) into place and seat the clips fully (2).