Fluid - Differential: Service and Repair

STANDARD PROCEDURE - DRAIN AND FILL

DRAIN





NOTE: Drain when fluid is at normal operating temperature.

1. Remove the bottom two carrier bolts (1) and drain fluid.
2. Inspect breather and clean if necessary.
3. Install bottom two carrier bolts (1) and tighten to 203 Nm (150 ft. lbs.).

FILL





1. Remove fill plug (1) from the right side of the carrier.
2. With axle level, fill carrier with lubricant to the bottom of the fill plug hole.
3. Install fill plug (1) and tighten to 68 Nm (50 ft. lbs.).